YIHUA 948 Upgraded 2 in 1 ESD Safe 80W Desoldering Station and 60W Soldering Iron- Desoldering Gun and Soldering Station °F /°C

Desoldering Station

Adjustable Temperature: 716~896°F

Temperature Stabilization: via PID Temp. Control

Sleep Mode: 5, 10, 15, 20, 30 mins Adjustable

Soldering Station

Adjustable Temperature: 392~896°F

Temperature Stabilization: via PID Temp. Control

Sleep Mode: 5, 10, 15, 20, 30 mins Adjustable

2-IN-1

You can use either the Soldering Station or the Desoldering Station based on your work, both the soldering iron and the desoldering gun connects to the station via a contact safe receptacle.

Pump Powered Suction

Vacuum Pressure: 0.5Mpa (measured from nozzle)

Vacuum Pump: Activated via Trigger (available after 3-minute preheat)

Desoldering: Suitable for double sided PCB through-hole desoldering, not applicable for components with square pins and computer PCB.

Better desoldering

The station will preheat for around 5 minutes when turned ON, and beep 3 times when the station is ready to go. This allows the station to heat the internal desoldering mechanism sufficiently to provide better heat transfer and quicker recovery time. So, the desoldering gun won’t clog up due to misuse under insufficient heating.

Sleep Mode

The station enters sleep mode when non-use is detected for longer than the set timer duration, and the desoldering gun/soldering iron idles at a lower temperature to reduce unnecessary wear on the nozzles/iron tips and the heating elements. You can set the timer from 1~99 minutes based on your needs, or set the timer value to 0 to turn OFF this function.